Stonelux Primer & Undercoat

Primer & Undercoat

StoneLux Primer and Undercoat has been specially formulated to prime and seal wood, MDF, concrete, brick, plaster, stone, marble, tile, ceramics and more.

Our high performance Primer & Undercoat adheres to the substrate to form a binding layer that is better prepared for application of all StoneLux paints, resulting in a better, longer lasting finish.

Suitable for use with all StoneLux paints
Ensures better adhesion of StoneLux paints
Increased durability
Assists coverage

Available Colours

BUY A SAMPLE POT

Please note: Colours displayed on screen may vary from the colour of the stone paints due your individual screen settings. We recommend you request a free colour chart by calling us on 01405 720281

Further Information

Suitable Materials

Wood & Wood Finishes
Marble
Plaster
Masonry & Brickwork
Granite
MDF
Stone
Tiles
Resin
Concrete
Pre-Painted Surfaces

Properties

Drying Time: In normal drying conditions allow a minimum of hours drying time between coats. Drying time can be reduced by circulating warm air around the painted surface. Completely cured within 72 hours under normal conditions.
Composition: Water-based
Coverage: 1 litre will complete (with the recommended 3 coats) an area approximately 2.5 meters squared. Coverage can vary depending on the condition and porosity of the substrate.
VOC Content: Minimal VOC content. This product contains max 6g/l VOC.

Application

By Brush

Stir thoroughly before application. To achieve a professional stone effect finish, prepare all surfaces well. Ensure the area is clean, sound and dry. Repair any damage with a suitable filler. Sand pre-painted and lacquered surfaces.
Using a natural soft bristled brush, apply an even, full, coat of Primer in the correct shade, to all surfaces. Allow 1-3 hours to dry depending on conditions. A second coat of primer can be applied where there is a significant colour change.
Using a natural soft bristled brush, lay an even, thin coat of StoneLux onto the surface. Do not over brush. Apply a MIMIMUM of 3 coats, allowing 1 - 3 hours drying time between coats, depending on conditions. If brush strokes remain, finish with light brush strokes or stippling. Fully cured in 72 hours.

By Spray

Stir thoroughly before application. To achieve a professional stone effect finish, prepare all surfaces well. Ensure the area is clean, sound and dry. Repair any damage with a suitable filler. Sand pre-painted and lacquered surfaces.
Using a gravity fed spray gun, apply an even, full, coat of primer in the correct shade to all surfaces. Wet film thickness should be between 150 and 200µm with no over coating on corners or joints. Allow 1 to 3 hours drying time, depending on conditions.
Using a gravity fed spray gun, apply 2 - 3 even, full, coat of StoneLux to all surfaces. Wet film thickness should be between 300 and 500µm with no over coating on corners or joints. Allow 2-3 hours to dry, depending on conditions. Fully cured in 72 hours.

Various psi settings can be used for a light or heavy finish (approx. 60psi for a medium textured finish).
If using a gravity fed gun, use a nozzle size between 1.8-2.5mm using a texture gun, use a nozzle size between 2-5mm.
If necessary, StoneLux can be diluted, using no more than 20% water.