An innovative fireplace paint which transforms your fireplace into an elegant stone feature with minimal effort.
A cost effective alternative to replacing your existing fireplace, back panel or hearth.
Select your chosen colour, tin size (with or without Primer) & stone finish below.
*Excludes Northern Ireland, Scotish Highlands, Channel Islands, & Isle of Man.
A water-based, durable, stone effect fireplace paint specially formulated for application onto fire surrounds, back panels and hearths. Our unique and exclusive ground stone formulation provides a very hard-wearing , breathable, stone effect finish that looks and feels like natural stone.
Stonelux Fireplace Paint is a cost effective alternative to replacing your existing fireplace, back panel or hearth.
Wood & Wood Finishes, Marble, Plaster, Masonry & Brickwork, Granite, MDF, Stone, Tiles, Resin, Concrete, Pre-Painted Surfaces
1L, 2.5L, 5L, 10L, 20L
Brush, roller or spray. We recommend natural bristled economy paintbrushes for use with all Stonelux Paints.
Washable once cured. Clean brushes with water.
Coverage: 7.5 meters squared per 1 litre. Coverage can vary depending on the substrate.
VOC Content: LOV VOC CONTENT 0-0.29%. VOCs (Volatile Organic Compounds) contribute to atmospheric pollution. EU limit value for this product(CatA/c):40g/l(2010) This product contains max 6g/l VOC.
Must be a minimum of 10cm away from the heat source. Do not apply in rain, temperatures below 10°C or above 30°C or if exposure to these conditions is likely during curing time.
Prepare all surfaces well. Ensure the surface is clean, sound and dry. Repair any damage with a suitable filler. Sand pre-painted and glossy surfaces. Apply at least one coat of Stonelux Primer & Undercoat in the recommended colour.
Stir well before use. Apply using an economy natural bristled brush or a roller. Apply a MINIMUM of 3 even coats. Avoid overspreading. Leave 2-3 hours drying time between coats. Do not over brush/roll. If brush marks remain, finish with stippling before final coat dries.
Stir well before use. Apply 2-3 full and even coats to the surface. Wet film thickness should be between 300 and 500µm. Do not over coat on corners or joints. Allow 2-3 hours drying time between coats. Various psi settings can be used for a light or heavy finish (approx. 60psi for a medium textured finish). Nozzle size: 1.8-2.5mm (gravity fed gun) or 2-5mm (texture gun). Paint can be diluted using no more than 20% water.